Darry you legend! The ICUSB1 and ICUSB2 were EXACTLY what I needed! Card is working beautifully, and sounds hella metal in Doom! Thank you very, very much!

1. Running the final revision 4 from Creative's website. 2. When I open CTCU to view the ISA PnP cards, it's not detected. 3. No, just the one slot. Graphics are Cirrus Logic on board. Running on a 1995 era 486 DX2. No PnP options in BIOS, running MS-DOS 6.22 I'm tempted to rebuild this PIII system …

Hi all, I bought an Awe64 CT4520 on eBay last week. The card was listed as recently repaired, tested, and working, only I can't get it to work. I have the Creative CTCM installed, and it detects my Vibra 16 normally (now), but when I swap in the Awe64, I get this "Bad Resource Data Checksum" error, …

I'm going to give that a shot next. But! Good news? Possibly! I took the ISA riser and card all out, cleaned the contacts with isopropyl again, and cleaned the riser out, sprayed all the ISA slots with canned air again, and it's working?! Things might be good to go, but things might also be still …

So I'm just going to reply with what I've done since the first post: I installed a fresh copy of MS-DOS, and copied over fresh drivers. The specific drivers I used were: PNPCFG folder from here: https://www.vogonsdrivers.com/getfile.php?fileid=37&menustate=42,35 Card drivers from here: https://www. …

I'm having errors with my only ISA card, a Sound Blaster Vibra 16 CT2960. If you could sell me a similar card, I would be really grateful. My first and only 486 was only acquired last week, and I'm trying to get it set up, and the only thing having problems is my sound card.

Hello all! I have a Unisys CWD4002 486 PC with a Sound Blaster Vibra 16 in the ISA slot. I have set up MS-DOS 6.22 on the computer, and everything is working normally there. When I was first setting it up, I managed to get the sound card installed and working, but after some other tweaks and changes …