Hey stynx, could you please also post RaveBench 1.11 or 1.1.1 (exact version number uncertain) here. According to some old forum entry it was part of the CD-ROM that came with VillageTronic's 3D Overdrive accelerator addon board. Thx, Vasco

I bought such a SBC recently as NOS, rev. G1D. Thanks for digging up the manuals! Apparently this is a Super Socket 7 chipset and supports K6-2/III with 500+ MHz and 100MHz FSB. Does your board enable the onboard 512K L2 PB WB cache? According to CTCM and SpeedSys mine doesn't. BIOS Code is 02/20/ …

I tried to flip that bit manually via ctchips, but - depending on set jumpers on JC1, JC2 and JC4 - the box either (reproducably) freezes, reboots or continues to work normally. The freeze and reboot behavior is highly jumper-config dependent (you'll change some and behavior goes from freeze to …

Hi Jan, thanks for your feedback. The JC4 jumper configurations had lots of similarities with the DACK0/1* hardware traps (disregarding actual hi/lo polarity), therefore I thought that'd be enough - apparently it's not. After comparing jumper settings for "SX vs SX-SL", "DX vs DX-SL" and "SX vs DX" …

Well now back to my question: Did anyone get this board (in any revision) working with a DX4-100 &EW (e.g. SK096) with L1 write back enabled or (as I am failing to try) a P24D DX2-66 &EW (SX955)? Apparently the P24D Jumper at JC4 in the "open position" may trigger the DACK0/1* pins of the SiS 471 …

After toying with this board around for today and googling half a day, I can verify the posts above. The jumper configs found on w3x/stason/th99/whatever and the (still) downloadable manual are for VER:1 boards (apparently first revision), and only partially match to later VER:1.1 and 1.3 boards. On …

MS-4138 VER: 1.1 Hope this helps. Filename 4138.jpg File size 990.51 KiB Views 337 views

Slight corrosion in the battery area yes, but the traces make contact. Already cleaned that with Isopropanol, same to the contacts of the PLCC CPU and the socket pins. Rest of the board looks good from visual inspection, no scratches not much dust etc. It was my first idea to test with DIPs too ( …

Thanks, Megatron - coincidentally those were the BIOSses I tried so far (at least 2hlm006 and one for BI-025C). :-) Maybe I should give the others a try too. Nonetheless, I was just wondering if the original BIOS of the board pictured above (which is visually exactly the same LM-103 REV2.1 [with …

Does anyone have the BIOS ROM images for this particular board at hand? I've got exactly the same board here with missing ROM chips and unfortunately I couldn't get any AMI BIOS for HT12/A working on it so far. Thx, Vasco