Have you tried running UNISOUND to configure the card and DOS? Then use correct settings to setup the sound in games. Unisound: https://www.vogons.org/viewtopic.php?f=62&t=72553&p=833659 This could come in very handy, thanks for pointing me toward it, As it turns out, the config file that DOOM …

Heya, Curious if anyone has any thoughts on what might be going sideways here, I walked through the following video... https://www.youtube.com/watch?v=ZiSM5pUGab4 ...in order to set up my Sound Blaster 16 VIBRA PnP card, and all seemed to go very well. When running Diagnose.exe all of the autodetect …

Display is working now, after installing drivers I find that despite being advertised as a TNT2 Pro it shows as a TNT2 M64 according to nVidia settings panel (classic eBay!). Probably your videocard is a chinese clone of TNT2 Pro based card with cut in half memory bus (64bit width instead of 128bit …

Tetrium wrote on 2023-07-20, 07:00: bifflog wrote on 2023-07-20, 01:04: Display is working now, after installing drivers I find that despite being advertised as a TNT2 Pro it shows as a TNT2 M64 according to nVidia settings panel (classic eBay!). Pic of the card?

Yes indeed, the jumper was the key! Nothing wrong with the card (at least, nothing defective) Display is working now, after installing drivers I find that despite being advertised as a TNT2 Pro it shows as a TNT2 M64 according to nVidia settings panel (classic eBay!). Also, when I launch Unreal it …

Do you have any other AGP video card to check if the slot works on that motherboard? Just to make sure. Working on acquiring another card as we speak, thanks! Some AGP ports are whimsical. Try to move gently the AGP card by the top while hitting the reset button. If it didn't help, try with a PCI …

Clean the contacts of the card with a paper towel and some rubbing alcohol. The contacts may look clean and still be dirty. Try the graphics card in another board. Check the card for any obvious damages like scratches, discolorizations, burn marks, bend pcb, etc (you said the pins look pristine, …

Hey! Curious if anyone has any tips, recently got a supposedly working TNT2 Pro to slot into a MEB-VM board (HP Pavillion 4450) but whenever I have it slotted in I get 1 long, 2 short beep code. Slot and pins are pristine to the eye, any advice beyond the card and/or the slot itself are just dead?