First post, by lucky7456969
- Rank
- Oldbie
Hi,
Please accept my apologies. It's me again.
I have 2 questions
1)
Where is the thread which discusses how to use the parallel port of dosbox megabuild? And also how can it pass thru to the usb port?
2)
If i have a booted image for netware server? the server will have an ipx address. But megabuild will have only an ip address which corresponds to the tcp/ip protocol. I can't remember how this exchanging works.
Do I first install some software in the booted image that converts the ipx address to the ip address then passes thru to winipap?
how does the tunneling server work? can i avoid all these setups when i use this piece of software?
Thanks
Jack