First post, by 9646gt
Hey guys, I have a celeron 500 system running 98 SE with 256MB RAM and the unofficial service pack 2.1a (heard later versions were bloated and basically offered nothing worthwhile). I installed a TrendNet TU2-ET100 version 3.0R and is hooked up to a USB 2.0 PCI card with NEC controller (same one Phils Computer Lab) has on his site. I am also using the 3.6 version of the USB 2.0 stack driver. I did not replace any of the files from that stack with older versions from the unofficial service pack when doing the install. When I click start and shut down, it sits at the shutting down screen with zero activity. If I press the power button it shuts off. I think it may be shutting down clean as it does not run scandisk when restarting. Is there an easy fix for this? I heard Realtek drivers could cause this back in the day but this chipset is starts with an AX8 (don't have it in front of me) so I don't think that is it. According to regedit fast shutdown is disabled by the service pack properly. Any ideas?