System Memory […]
Show full quote
System Memory
Four dual inline memory module (DIMM) connectors are provided on the system board. The DIMM connectors are powered by +3.3 volts. Each DIMM connector is a 168-pin, gold-lead socket. For the pin assignments, see “System Memory Connectors” on page 30.
The system board supports:
* A maximum of 512 MB (128 MB modules in all four connectors).
* Dynamic random access memory (DRAM) only.
* 64-bit (EDO) and 72-bit (ECC) wide memory modules.
Any configuration of DIMMs is acceptable. Characteristics required by DIMMs include:
* 168-pin, unbuffered +3 V modules only.
* Gold-lead tabs only.
* 60 nanosecond access speeds only.
* Height of no more than 3.81 cm (1.5 in.).
* To enable error-correcting code, all installed memory must be of the ECC type (a combination of ECC and nonparity types is configured as nonparity)
Note: Single inline memory modules (SIMMs) are not supported in the PC 365.