VOGONS


First post, by Robin4

User metadata
Rank l33t
Rank
l33t

Has anyone maybe have information or manuals, or documents about this isa card?

s-l1600.jpg

~ At least it can do black and white~

Reply 1 of 6, by pentiumspeed

User metadata
Rank l33t
Rank
l33t

This is 8 bit IDE for old miniscribe 8 bit IDE hard drive, 20mb, 40mb. Limited due to EPROM means can only handle few types of miniscribe hard drives.

Cheers,

Great Northern aka Canada.

Reply 2 of 6, by luckybob

User metadata
Rank l33t
Rank
l33t

its the base board for an IDE hard card: https://en.wikipedia.org/wiki/Hardcard

You can probably remove that bios and it will probably work as a dumb IDE adapter card.

It is a mistake to think you can solve any major problems just with potatoes.

Reply 3 of 6, by Robin4

User metadata
Rank l33t
Rank
l33t

So its actually not a stand alone ISA card.. But a part of a hardcard?

~ At least it can do black and white~

Reply 4 of 6, by luckybob

User metadata
Rank l33t
Rank
l33t

it CAN be stand alone. But it was likely designed to go with a certain selection of ide hard drives. slotted into an isa card slot, it even provides power for said drive via the 3x2 pin connector at the top of the card.

It is a mistake to think you can solve any major problems just with potatoes.

Reply 5 of 6, by mdog69

User metadata
Rank Newbie
Rank
Newbie
luckybob wrote on 2021-02-04, 16:26:

its the base board for an IDE hard card: https://en.wikipedia.org/wiki/Hardcard

You can probably remove that bios and it will probably work as a dumb IDE adapter card.

Might be able to use the interface with a suitable XT-IDE ROM.

or alternatively, pull the IRQ link (so it uses neither IRQ), and set the I/O link to a non-clashing address, and use the board with XT-IDE and a motherboard or 16bit ISA card IDE interface.

Reply 6 of 6, by pentiumspeed

User metadata
Rank l33t
Rank
l33t

Problem with this interface card is 8 bit IDE. Very rare hard drives supports this but ideas to use it is good.

Cheers,

Great Northern aka Canada.