xjas wrote on 2020-01-18, 12:05:

Awesome job! Looks a hell of a lot more pro than the stand I made (I ended up buying one of these too. 😜 )
20200118_040950.jpg
Yeah yeah... it 'works' though, as in, it holds the monitor off the table and doesn't tip over. (If I were Apple, could I charge $999 for this?)

Looks good to me! I was going to screw the old stand onto a block of wood or something to give it more stability but never got around to it. Glad I stumbled upon this more elegant solution.

I wish I had 3D modeling skills. I would design a beige CRT case for this little monitor!

dionb wrote on 2020-01-18, 13:55:

Do you have a link to the design file for that stand? I even managed to lose mine (for obvious reasons this is my go-to monitor for portable use), so a fitting stand that is actually useful too would be great 😀

Yes, it is on Thingiverse:
https://www.thingiverse.com/thing:3506869

It looks like someone made a barcade with the 8" model. I'd like to print just the part for the monitor but would need to take the bezel/frame off the Eyoyo.

https://www.thingiverse.com/thing:3861808

EDIT: My mistake. The monitor housing is not 3D printed. The model is for the bezels and button panel.