VOGONS


First post, by RiP

User metadata
Rank Member
Rank
Member

I try to get my ST02 to work but it reports: "SCSI Host Adaptor Failure"
The floppy port works fine though 😕

gIc3fA7V_t.jpg

Reply 1 of 2, by Warlord

User metadata
Rank l33t
Rank
l33t

make sure the scsi cable is terminated. Check the drive ID jumpers and that its not sharing same ID with the controller, floppy or other device on the cable.

Try connecting just the drive to the controller with no floppy attached as well.

Reply 2 of 2, by RiP

User metadata
Rank Member
Rank
Member
Warlord wrote:

make sure the scsi cable is terminated. Check the drive ID jumpers and that its not sharing same ID with the controller, floppy or other device on the cable.

Try connecting just the drive to the controller with no floppy attached as well.

Thank you, just terminated the HDD and ST02 detected it 😎