First post, by Sev80

User metadata
Rank Member

I picked up a dfi-k6xv366 that was assumed to be not working due to capacitors. I recapped the entire board and it still wouldnt work, and with enough fiddling around, I got it to boot and work on a k6-2 333 that uses a 2.2v core voltage, but if I put in any other cpu that runs at a higher core voltage, the board is completely dead. I desoldered both the mosfet's and used a tester to test them and they passed.

Has anyone else seen a similar issue? Wondering what else I can check?

I replaced every single capacitor on the board and checked to make sure not only that they are properly soldered with a multimeter but checked each one is getting voltage...