shuttle AV18E2 no 80 pin conductor cable installed \ VOGONS

shuttle AV18E2 no 80 pin conductor cable installed

Topic actions

Post a reply

First post, by egbertjan

Posted on 2020-04-29, 23:06

egbertjan Offline

Rank Member

Rank: Member
Posts: 133
Joined: 2019-08-20, 08:52
Location: The Netherlands

I have a shuttle AV18E2 motherboard and the white ide connetor gives the following error no 80 pin conductor cable installed. I have already used several 80 pin ID cables, but nothing helps to get the message out. The hard drives that I connect to the white ide port are also very slow due to this message. The other blue ide port is working fine.

Who knows what I can do to fix this or is the motherboard broken?

I would like to use that motherboard to install Windows 98se to play old games.

Reply 1 of 2, by buff

Posted on 2020-04-30, 00:26

buff Offline

Rank Newbie

Rank: Newbie
Posts: 29
Joined: 2018-09-07, 21:31

Check for bloated caps?

You can plug the other drive in the Primary, and just not use that IDE port. BIOS should have an option to not halt on errors. Should be on the first page.

Reply 2 of 2, by Kahenraz

Posted on 2021-08-07, 00:55

Kahenraz Offline

Rank l33t

Rank: l33t
Posts: 3966
Joined: 2004-01-22, 04:57

I have the same problem with my Shuttle HOT-675V motherboard. I know that all of the capacitors are good because I replaced them all myself with genuine Nichicons.

This is super annoying.

I tried shorting pin 34 to ground manually but it didn't make a difference. In this case I used a CF adapter but the error is the same on a regular hard drive. The pin is just easier to access here on the adapter.

Go to top of page Go to top of page

Back to General Old Hardware

Main menu

Common searches