Wow, this is a very amazing project! Good job!!

ALEKS wrote on 2020-06-07, 15:29:

* Two IDE Interfaces with two channels each (primary master-slave, secondary master-slave)

Alexandru, is it possible to obtain a PAL sourcecode ?
I would like to implement a single secondary IDE apator board.

I've just bought early ISA 486 Motherboard and 486 DX-50 and was searching for a proper Multi I/O card for it.

I have two 2.88 floppy drives and was thinking about putting one of that drives into this build. One is PS/2 style and requires special power through the data cable and seems like this board supports it. Definitely, it's the best Multi I/O board for my purposes so I'll definitely build at least one 😀

Alexandru, very nice job, thank you for your efforts and contribution to the retro-community.