Mapower PD-80 PSU issues \ VOGONS

Mapower PD-80 PSU issues

Topic actions

Post a reply

First post, by Errius

Posted on 2020-09-13, 10:20

Errius Offline

Rank l33t

Rank: l33t
Posts: 2756
Joined: 2015-12-16, 19:16
Location: Lave Station

Hello guys. I'm trying to debug this external drive PSU. It's a Mapower PD-80 and just outputs the standard 12V/5V over a couple of Molex connectors.

However, this particular unit is putting out 9V instead of 12V. Is this a capacitor problem?

(The gunk on the capacitors is not electrolyte but glue from a couple of labels that I pulled off. The capacitors have not burst.)

Is this too much voodoo?

Reply 1 of 2, by quicknick

Posted on 2020-09-14, 00:58

quicknick Offline

Rank Oldbie

Rank: Oldbie
Posts: 634
Joined: 2017-10-30, 23:53
Location: RO

Secondary capacitors appear to be Fuhjyyu "brand", which is one of the worst. Responsible, among others, for the deaths of countless Antec PSU's in the mid-00s. Replace them, and also check the fat one although it looks to be made by Hitachi so it should be still good.

Reply 2 of 2, by Errius

Posted on 2020-09-14, 10:57

Errius Offline

Rank l33t

Rank: l33t
Posts: 2756
Joined: 2015-12-16, 19:16
Location: Lave Station

Ok, thank you!

Is this too much voodoo?

Go to top of page Go to top of page

Back to General Old Hardware

Main menu

Common searches