VOGONS

Search

Common searches

MicroniICS M6Pi how to power up this mobo?

Topic actions

First post, by Callahan

Posted on 
User metadata
Rank Member
Rank
Member

Hi,
I want to power up this motherboard but... there is no such jumper to short...
PSU connector is ATX...
Instruction says nothing , just "power up system" and layout shows nothing such as jp pwr or any of that...
Anyone?

Cpq: ap550(2x1G/256k), sp750(2x900/2MB), 5100(2xpII300)
TD-30 2xP166 NT 3.51
HP Vectra XU 6/200 2x PIIOD 512MB FPM Banshee
Super S2DG2@550/2MB SCSI 15k V5 5500
P4T533-C P4 3,06 Ti4600
Dell T700r @P3-700 V3 3500
PR440FX-2x PIIOD Voodoo 4500 PCI r320 CT1920

Reply 2 of 3, by Callahan

Posted on 
User metadata
Rank Member
Rank
Member

It's an ordinary motherboard, here is an instruction and layoyt 1:1 as mine
https://www.infania.net/misc/moboarchive/Micronics/m6pi.pdf

I've just discovered that mobo powers up if i short circuit green and black wire at psu connector, then mobo boots fine and stays on as long wires are shorted... but this unusual method to power up...heh...
It must a very old "atx standard" 😉

Cpq: ap550(2x1G/256k), sp750(2x900/2MB), 5100(2xpII300)
TD-30 2xP166 NT 3.51
HP Vectra XU 6/200 2x PIIOD 512MB FPM Banshee
Super S2DG2@550/2MB SCSI 15k V5 5500
P4T533-C P4 3,06 Ti4600
Dell T700r @P3-700 V3 3500
PR440FX-2x PIIOD Voodoo 4500 PCI r320 CT1920

Reply 3 of 3, by Callahan

Posted on 
User metadata
Rank Member
Rank
Member

I think i'm completely blind...maybe by the covid 😉
there is a JP40 called soft pwr... but it's nowhere showed in instruction and on motherboard is hard to seen-near ide ports.
Nevermind, thanks

Cpq: ap550(2x1G/256k), sp750(2x900/2MB), 5100(2xpII300)
TD-30 2xP166 NT 3.51
HP Vectra XU 6/200 2x PIIOD 512MB FPM Banshee
Super S2DG2@550/2MB SCSI 15k V5 5500
P4T533-C P4 3,06 Ti4600
Dell T700r @P3-700 V3 3500
PR440FX-2x PIIOD Voodoo 4500 PCI r320 CT1920

Go to top of page Go to top of page
Back to General Old Hardware
Close window
Close window