Hello !

I hope this is the right place for that kinda topic. So, I tried getting this problem resolved on the VCFED forum, but they don't seem to keen on giving any more help. I am now trying here to see if anyone may have any info to help me.

I have installed a SCSI card (ST-01) in my Tandy 1000 SX, before that, there was a RLL controller (ST-11R). The packet driver for the Etherlink III still loads fine, but when I try to do a ping with mTCP's ping command, it doesn't work anymore, nor does the DHCP. I tried different IRQs, different addresses, different software addresses for the packet driver and yet, it still doesn't works.

Here are the configs of the cards:

NIC: IRQ 3, address 280
SCSI: IRQ 5, address unknown, not specified in the manual
Packet driver: software address ox60 (I tried other address too)

There are other cards in the computer, serial and parallel combo card, SB 2.0 and a VGA card, but none of em seem to have parameters that conflict with the NIC, so I'm kinda lost on what to do here. Thanks for any help.