I am thinking maybe it has something to with with CTMU - it seems to only let you assign between 0 and 3
When I set up Duke 3D, it was only listing DMAs 5,6,7 for 16-bit - and the game runs fine
I think PNP cards were okay under Windows but NO GOOD under DOS.
Well its likely that you got an extra-cheap card. A hint would be that the 16-bit portion of the ISA connector is blank at the top side.
1+1=10
No. it's a 16-bit card -4270. When I run diagnose it tests both the 8=bit and 16-bit audio
16-bit audio can be squeezed through an 8-bit bus too and plugging in the 16-bit connector does not neccessarily mean the 16-bit bus is actually used.
Are you sure its not CT-4170? That is the 8-bit variant. I have one here.
1+1=10
Opps - you are right - it is CT-4170. Are you saying that is actually an 8-bit card? That explains a bit....
Yea Creative made their cards even cheaper towards the end. I'm not sure if any games are honestly affected by this. The card should "just work".
I was actually considering getting this off ebay:
http://www.ebay.com/itm/Creative-Labs-CT2230- … =item2eba65c38e
On the other hand what I have no works - maybe better to leave well enough alone
.... an thanks to everyone who made a comment here. You guys were very helpful 😀
CT2230 is one noisy card!
but it does work without much trouble
