I bought one of these Packard Bell labeled cards for my Dos6.22/Win3.11 build. Once I found the proper Aztech Voyager drivers, the card works fine in DOS. However, in all instances except once in Win 3.11, the system hangs upon entering the information concerning the base address, IRQ, etc., forcing a restart. In one instance, it actually worked, but after a restart, the computer would refuse to boot DOS, hanging on the DEVICE=C:\VOYAGER\DRIVERS\EEPROM.SYS /883C0001 line

I have the card setup for the EPROM Setting per the jumper on the card. The alternative jumper position for Software Setting prevents the computer from POST-ing.

I'm using the VY212 driver package, which is the right driver for this card as far as I'm aware.

Any thoughts?