I just installed Windows 98SE on my P233MMX and I have a Vibra 16S ISA card. Its properly detected and showing in the device manager.
When adjusting volume, I can hear the noise increasing ... but when I go to sounds in control panel and try to play a sound, its quiet, no sound comes out.
Im using the spk out port on the card with headphones attached to it.
Do I need to install any other software or drivers?
What does control panel say about this peripheral? DMA/IRQ conflict?
PC#1 Pentium 233 MMX - 98SE
PC#2 PIII-1Ghz - 98SE/W2K
No conflict and when i just ran duke3d setup and tested sound after adjusting irq and dma to windows i can hear the sound. Strange?
Omarkoman wrote on 2023-04-12, 23:20:No conflict and when i just ran duke3d setup and tested sound after adjusting irq and dma to windows i can hear the sound. Strange?
Nope, I had that with a sound card but I had to set IRQ and DMA in BIOS. Setting the needed addresses to ISA solved the issue.
Nice to see it works fine now 😀 Enjoy
PC#1 Pentium 233 MMX - 98SE
PC#2 PIII-1Ghz - 98SE/W2K
