Try Aureal's generic 2041 drivers.

Those worked for me with Quake 3 and Voyager Elite Force on a Turtle Beach Montego II.

Joseph_Joestar wrote on 2024-03-14, 09:47:

Try Aureal's generic 2041 drivers.

Those worked for me with Quake 3 and Voyager Elite Force on a Turtle Beach Montego II.

Thanks Joseph! The 2041 worked perfectly with Quake 3. On a side note, I can't believe how easy it is to install Vortex drivers VS Creative. Live 5.1 is a pain and Audigy 2 ZS is a nightmare.

I did notice that A3D is not enabling automatically when Quake 3 starts. I have to go enable it each time. I created autoexec.cfg in baseq3 and added "s_enable_a3d" but for some reason the autoexec.cfg isn't executing automatically when running Quake 3. If I run /exec autoexec.cfg then the config file runs and A3D is enabled. How to do you get your A3D to start automatically?

zuldan wrote on 2024-03-15, 03:17:

I did notice that A3D is not enabling automatically when Quake 3 starts. I have to go enable it each time. I created autoexec.cfg in baseq3 and added "s_enable_a3d" but for some reason the autoexec.cfg isn't executing automatically when running Quake 3. If I run /exec autoexec.cfg then the config file runs and A3D is enabled. How to do you get your A3D to start automatically?

Unfortunately, I don't think it's possible for Quake 3 and Elite Force (same engine).

Both games automatically disable A3D on startup, regardless of the previous setting. I had to manually turn it back on every time.