Help for using SCC-1 + CM64 - what cable will do the job? \ VOGONS

Help for using SCC-1 + CM64 - what cable will do the job?

Topic actions

Post a reply

First post, by lucasdaytona

Posted on 2011-11-02, 11:48

lucasdaytona Offline

Rank Newbie

Rank: Newbie
Posts: 18
Joined: 2011-10-11, 15:17
Location: Brazil

Hello people.

I'm having some trouble to decide what cable to buy, I have a SCC-1 and mine CM-64 is almost here (customs delay), and I'm wanting to buy the cables at once. SCC-1 have a 5 pin mini din(that is very different from pc keyboard mini din), the manual says that I must use a adapter cable included with my SCC-1(but mine didn't have this cable), so, this is the problem, please give me some help.

Thank you!

Reply 1 of 2, by 5u3

Posted on 2011-11-02, 13:49

5u3 Offline

Rank Oldbie

Rank: Oldbie
Posts: 1567
Joined: 2005-09-06, 12:23
Location: Vienna, Austria

These mini-DIN to DIN cables are very hard to find, but rather easy to build yourself (at least if you can find the right mini-DIN plug).

Here is the pinout for the cable (normal DIN plug going into the CM64 on the left, on the right side the mini-DIN plug for the SCC-1).
The diagram shows both male ends of the cable. The pins marked red are used for shielding, which only should be connected on the MIDI-OUT end of the cable (in your case, the mini-DIN connector).

Reply 2 of 2, by lucasdaytona

Posted on 2011-11-05, 13:03

lucasdaytona Offline

Rank Newbie

Rank: Newbie
Posts: 18
Joined: 2011-10-11, 15:17
Location: Brazil

Thanks!

I will try to find the correct mini-DIN.

See ya.

Go to top of page Go to top of page

Back to PC Emulation

Main menu

Common searches