rasz_pl wrote on 2022-10-17, 23:43:
nothing happens aka psu doesnt start? that can mean total short, standby circuit bad, or standby detecting something it doesnt like etc
first thing first, unplug supply and measure resitance on 5 12 3.3 lines and on PSAUX 12
PSU is fine, Enermax 365Watt, used it to test OR840, P3C-D and P3C-E's.
And no... didnt check the adapter, i really assumed that was the adapter for the Mainboard, or more remembered "that must be the adapter", but as memory's fade after 15 years, i obviosly remembered something wrong.
Turns out, the adapter I have is an ATX to ATX/EPS Adapter... as male to female and male to female - must have been for a total different system.
I did check in general WTX Pin Layout and was a bit woundering.
Man i feel dumb, well.. i still remember french language.. "Je ne comprende pas + Voule vou couche avec moi + Bonjour and Croissant" - which is i bet much wrong aswell 😀
Horun wrote on 2022-10-18, 00:55:
Agree. Can you make sure the WTX adapter is the proper one. There are two types depending on the motherboard
The location of the PWRon and Powergood plus the voltage mains are different between the two.
Also at the Iwill web archive they sold a "bare bones" with board, case and 460w psu.
Yeah, cause when i was woundering, i noticed that the Pwr-On (green one def isnt in the right place)
Thanks so much for the both names of the possible PSU i could use, which also give away the Pin-Layouts needed !!
Love you 2 so much already 😀)
With bit luck i already found both PSU nearby and cheap too - still need to know/find out if they have 8 Pin with 8 wires or 6 wires - since i need the 6 wire one, the 8 wire is again the EPS one.