Clipper Editor For Windows 3.11 \ VOGONS

Clipper Editor For Windows 3.11

Topic actions

First post, by Nathan

Posted on 2010-03-30, 21:15

Nathan Offline

Rank Newbie

Rank: Newbie
Posts: 40
Joined: 2009-12-30, 01:12
Location: Brazil

Hello,
Today I was searching for my old Clipper 5.2e Installation Disks. I found them and installed on my DOSBox running Windows 3.11, but I haven't found my FiveWin Disks, then I've ordered by eBay, but I only use it for GUIs, when I want to develop some DOS application I like to compile with pure Clipper, then I want to know a good editor for Windows 3.11, that haves syntax highlighting(if possible) and auto-identation.

Best Regards,
Nathan Paulino Campos

Reply 1 of 2, by dbarton

Posted on 2010-03-31, 08:47

dbarton Offline

Rank Member

Rank: Member
Posts: 142
Joined: 2005-02-10, 05:22

http://www.semware.com makes an editor I used to use for Clipper.

You don't usually need Dosbox to run Clipper programs. They run in XP.

Reply 2 of 2, by Nathan

Posted on 2010-03-31, 17:11

Nathan Offline

Rank Newbie

Rank: Newbie
Posts: 40
Joined: 2009-12-30, 01:12
Location: Brazil

Thanks, and I know that they run on XP, but it's alot more funny and better to develop on a Windows 3.11 than XP. 😉

Go to top of page Go to top of page

Back to DOSBox General