I have an AWE64 Value CT4520 and I need help to set the jumpers for Line-out/speaker to Line-out, I found a page here:
http://pbclub.pwcsite.com/PBInfo/Jumpers/Soun … WE64-VA-12.html
that says "CN7" is the one I need to set but it does not mention which pins need to be open or closed.
CN7 should have two jumpers set, one for each channel. Just move both jumpers by one pin.
Should I place the jumper horizontally or vertically
[A] [0] Horizontally - A+B closed and L+R closed
[L] [R] [0] 0 not used
or
[A] [L] [0] Vertically A+B closed and L+R closed
[R] [0] 0 not used
It's not a jumper block, but an internal header.
1 Left channel line level audio out
2 Right channel line level audio out
3 Pin is cut to provide keyed connection
4 Analog Ground
5 Left channel speaker audio out
6 Right channel speaker audio out
Sorry I dont understand Firage from what you said can you tell me how to put the jumpers for line-out?
The pins aren't for jumpers. It's a connector.
You have both jacks for line level out and amplified speaker out at the back in any case.
