First post, by britain4
I can’t run either the Win95 or Win98 setups from my HDD - copied the files over from the install disks. Running “setup” for Win95 hangs Scandisk and gives an “out of memory” message, win98 setup doesn’t start at all and just exits back to a DOS prompt.
This is on a 600mhz Celeron with 128mb memory
Any ideas?? The original hard disk boots fine on the same laptop and reports the full amount of RAM
- P-MMX 200MHZ, PCChips M598LMR, Voodoo
- P-MMX 233MHz, FIC PA2013, S3 ViRGE + Voodoo
- PII 400MHz, MSI MS6119, ATI Rage Pro Turbo + Voodoo2 SLI
- PIII 1400MHz, ECS P6IPAT, Voodoo5 5500
- Toshiba Libretto 110CT, 300MHz, 96MB RAM