hello
could you please help me with identify this mobo ?
thanks
Some items for sale 😀
https://docs.google.com/spreadsheets/d/1YNG8R … dit?usp=sharing
Have almost the same..and yours has all jumpers labeled.
Whats the problem with it?
Provide a picture of the back of the mobo, might help.
HP Z420 Workstation Intel Xeon E5-1620, 32GB, RADEON HD7850 2GB, SSD + HD, XP/7
wrote:Have almost the same..and yours has all jumpers labeled.
Whats the problem with it?
what is the "name" of your mobo ?
the problem is that there was no memory modules on the mobo there are DIP16 DIP18 and DIP20 sockets without the description. I dont't know how to configure it.
Right now after turn on I am receiving low/high sound.
Some items for sale 😀
https://docs.google.com/spreadsheets/d/1YNG8R … dit?usp=sharing
Ah OK. I cannot see on your photo what is installed. You should 1st try to populate only bank 0 completely and leave bank 1 empty.
Do you have a CGA card? Then you can try the Landmark/Supersoft ROM, gives you diagnostic output without RAM installed 😉
wrote:Ah OK. I cannot see on your photo what is installed. You should 1st try to populate only bank 0 completely and leave bank 1 empty.
Do you have a CGA card? Then you can try the Landmark/Supersoft ROM, gives you diagnostic output without RAM installed 😉
i will try 😀
btw what is the model of your mobo ?
Some items for sale 😀
https://docs.google.com/spreadsheets/d/1YNG8R … dit?usp=sharing
No-name China? 😉 Dont know, also no label on it.
Cool. You don't see too many standard formfactor XT motherboards with integrated I/O and floppy controller (that's what the card edge connector is for)
"Will the highways on the internets become more few?" -Gee Dubya
V'Ger XT|Upgraded AT|Ultimate 386|Super VL/EISA 486|SMP VL/EISA Pentium
What does it say in between the bottom 2 ISA slots?
HP Z420 Workstation Intel Xeon E5-1620, 32GB, RADEON HD7850 2GB, SSD + HD, XP/7
wrote:Cool. You don't see too many standard formfactor XT motherboards with integrated I/O and floppy controller (that's what the card edge connector is for)
Ah OK, thanks for confimation. I suspected this as it is a 34 Pin connector, but never tried.
Just powered on mine, it says
"PAC Personal Computer"
on startup and counts 640 k of RAM in the config shown in the picture. However, such board should POST with only 64k installed...so you dont need all the chips...
