First post, by p6889k
I have dual PPro motherboard MS-6103 that has a 10pin header marked USB1 USB2. I would like to connect USB cable with rear bracket to it, but I'm afraid to plug modern 9pin USB cable to the board's 10pin header as I'm not sure that the headers on these pentium boards had the same pinout as modern boards. Also, on modern boards the 10pin header has 1 blank pin so that the connector can be keyed correctly. The 10pin connector on this board has all 10pins present.
Any advice? Thank you.
Sinclair ZX Spectrum 48k, 48k+, 128k, +2
Amiga 1200, 68030/40mhz
386DX/33, ET4000, SBPro2, MT32
Dual PPro/200, Millennium II, Voodoo 2, AWE32, SC-55
etc.