First post, by Nemo1985
Hello, some hours ago I put back in place this mb (https://4.bp.blogspot.com/-HPRP48X6cos/V2O8bq … Corp%2BP55C.jpg), but despite paying attention (clearly not enough), I connected the mb with one pin left on the right side, then I switched on the psu, it went to protection immediately, then I switched it off after some moments, but now when I power on the system I just get a blank screen with no beeps, on the debug card I just get 0000 code, with or withtout cpu and ram, I noticed that the cpu gets warm anyway.
I tried another cpu, another bank of sdram and another video card, same result...
Did I kill the system for good?