First post, by Mismatch2
- Rank
- Newbie
Hello everybody and thanks for all the info i've managed to scravenge off this site over the past couple of years... thing is, for this issue, i'm at a loss and have finally decided to make the leap and come and ask for some help.
So, whats the deal? I have a 99% stock IBM Aptiva 2168, running a Pentium 75Mhz, 8MB of ram and I've thrown in a PCI S3trio64+ graphics card for good use. A fresh install of MS-DOS 6.22 and set up my config.sys (dos=high, himem.sys, dos=umb,files=40 and Device=C:\Mouse.sys) the sound blaster was auto configured.. and thus I would like to say everything is ok.. here..
As for the autoexec.bat i've got setblaster=A220 I5 D1 H5 P330 T6 and LH c:\sb16\sb16set /P /Q....
I'm writting this down so as if the error is here perhaps somebody could point it out.... BECAUSE... well, because i've installed Duke3D VER.1.3D. I've run the sound setup and it has my card down as a sound blaster.. and if I test the music / sound it works. I've set the mouse up as a two button jump and fire. then I launch the game... It runs fine but as soon as I move the mouse, the game freezes... and the PC just hangs...
So, my question is... why?
hope my subject is in the correct place, and I hope somebody can help...Cheers!
"you have eliminated the impossible, whatever remains,however improbable, must be the truth?"