Thanks your help. I finally managed to have the game running in Dos Mode of Windows 98 without a problem. But with Dosbox it has been impossible, it runs but awfully slow and I was tired of trying. Thank you very much.

it doesnt work either with irq 7 dma 1

core: dynamic cicles: 3000

There is no switch to avoid joystick detection. When it is unplugged it is not detected. The settings for sound card are the following: port 220 Irq 5 DMA 1 this is according to the game manual. I run the install.exe program of the game and set above mentioned data, I also modified the Dosbox.conf …

Yes, I tried with the Joystick unplugged, I only get a frozen black screen

Has anybody succeed in making this game to work under Dosbox? At the beginning I thought it was a joystick problem, now I think that it is solved by writing in the conf file Joysticktype=2axis timed. However, after the calibration of the joystick the game freezes and do not respond anymore. Somebody …

Thanks, augnober. Thanks,...., wd

Ok, understood the instructions for frontends and the sintax for the config file. However I find the instructons for CVS and Diff a little disappointing, since nobody is born wise. At least, can you tell me a place where I can read about diffs and CVS's, I cannot figure out from the air and you do …

It would be nice if you write a tutorial or some instructions as to know what these things are: diff frontend cvs sintaxis to be used in the config file etc. It will be easier for a lot a people to understand what is written in the forum. Congratulations for the nice work you have done to bring back …

My PC: Pentium Double Core 3,2 MHz Graphic: Nvidia GeForce 6700 XL Realtek High Definition Audio USB Joystick The Problem with Pacific Strike (Origin 1994): The game starts with a screen for calibrating the joystick. Every attempt failed because the program tells "wrong data, try again" until after …

Thanks, with the patch and the new dll's now it works perfectly.# Why they do not do it in the original version?

Does not work. Another peculiarity: When the joystick is connected and I start Dosbox, it is impossible to write anything in the dosbox window. When I disconnect the joystick, then appears the blue screen on the Dosbox window

dosbox bersion: 0.65 the joystick is recognized under windows 98 SE and working properly in that evironment

PC: Intel Pentium 3, 600 Mhz Graphic Card: Matrox 200 Sound Card: On board Crystal Joystick: "Normal" 15 pin conection to gameport Operating system: Windows 98 SE Problem: I've installed red Baron (floppy disk version). The Dosbox recognize the Joystick as a CH Pro but the game do not recognizes it. …