Intel486dx33 wrote:

It‘s true. And a red led light when the sad face is displayed. Maybe it was designed to be friendly to people with hearing disab […]
Show full quote

It‘s true. And a red led light when the sad face is displayed.
Maybe it was designed to be friendly to people with hearing disabilities. ( deaf ).
Or when in a loud place or a place with allot of noise or when someone has headphones on.
That would make sense since this computer runs loud with all the fans going.

Meant to evoke an association with PA-RISC gear?

GordonFreeman wrote:

Huh... interesting. Could you show a picture of what it looks like normally when the system is running?

It’s stored deep in my garage right now and I am to lazy to take it out.
Sorry. It’s winter, raining, and cold right now. Maybe in the summer.

Errius wrote:

This looks like a workstation version of the Netserver LC3, though the LC3 lacks an AGP port. (The Netserver E60 has an AGP port, but lacks VRM slots.)

Kind of, these where in service at the same time as the Netserver LC.
They are both loud computers that run NT4.0

Arctic wrote:

Do you still have the CPU fan and shroud for it?
Could you take a picture of them?

Thank you 😀

If you need a fan shroud and cpu duct ( parts 89a and 89b ) . I would forget about trying to 3D print one.
Just add a fan to the rear of case and add heat sinks with fans to you cpu’s.

Blow the air out the back of the case.

My HP Kayak motherboards are made in Singapore and Malaysia.

HP use to have really great warranty support if anything ever went wrong with these computers all I had to do was call there customer support and they would ship me out a new part with out prejudice.
No questions asked.

That’s why I really liked HP computers. Great support.