Error =BIOS INT14: Unhandled Call AH=81 DX=0 \ VOGONS

Error =BIOS INT14: Unhandled Call AH=81 DX=0

Topic actions

This topic is locked. You cannot reply or edit posts.

First post, by Raymo99

Posted on 2018-06-05, 19:48

Raymo99 Offline

Rank Newbie

Rank: Newbie
Posts: 2
Joined: 2018-06-05, 19:39

Hi folks,

Have an error in the status box of DosBox
Error =BIOS INT14: Unhandled Call AH=81 DX=0

I'm running Dosbox in Win 10 64 bit
Is 64 bit causing this error?

Trying to run an old kenwood radio dos package called KPG67D, it's for programming Kenwood walkie talkies.

I'm using this line in the cong file: serial1=directserial realport:com2
my serial device is set up as Com2
so all should be good, except for the error in the status window,

really would appreciate any suggestions, this is my third evening trying to solve this.

Thanks
Ray

Reply 1 of 4, by Qbix

Posted on 2018-06-05, 20:04

Qbix Offline

Rank DOSBox Author

Rank: DOSBox Author
Posts: 11233
Joined: 2002-11-27, 14:50
Location: Fryslan

did you forget to load one of the drivers (of the program you are trying to run) ?

http://www.delorie.com/djgpp/doc/rbinter/ix/14/81.html

all those calls refer to driver packages. not something obvious that dosbox should have

Water flows down the stream
How to ask questions the smart way!

Reply 2 of 4, by Qbix

Posted on 2018-06-06, 06:23

Qbix Offline

Rank DOSBox Author

Rank: DOSBox Author
Posts: 11233
Joined: 2002-11-27, 14:50
Location: Fryslan

thinking of it a bit more.
It can be that the radio package is just doing a detection run for all kinds of possible drivers. So it might be fine to ignore it, if it works.

Water flows down the stream
How to ask questions the smart way!

Reply 3 of 4, by Raymo99

Posted on 2018-06-07, 06:28

Raymo99 Offline

Rank Newbie

Rank: Newbie
Posts: 2
Joined: 2018-06-05, 19:39

Thanks,
I actually found a solution which didn't require the use of DosBox. There is a windows version of Kenwood software.

Cheers
Ray

Reply 4 of 4, by johnkinesis

Posted on 2019-12-17, 07:25

johnkinesis Offline

Rank Newbie

Rank: Newbie
Posts: 1
Joined: 2019-12-17, 07:22

Raymo99 wrote:
Thanks, I actually found a solution which didn't require the use of DosBox. There is a windows version of Kenwood software. […]
Show full quote
Thanks,
I actually found a solution which didn't require the use of DosBox. There is a windows version of Kenwood software.

Cheers
Ray

hello man, do you have a link how to download that windows version of kenwood software? i have the same problem, i can't program repeater. TK-768G Kenwood. Thanks for the response.

Go to top of page Go to top of page

Back to DOSBox General

Main menu

Common searches