again
>the only thing you should measure is drain-source junction
while in circuit, powered down, in diode multimeter mode, both directions

low resistance gate-source can mean blown LX1682, would result in same symptoms, testing will require desoldering to check

rasz_pl wrote:

again >the only thing you should measure is drain-source junction while in circuit, powered down, in diode multimeter mode, bot […]
Show full quote

again
>the only thing you should measure is drain-source junction
while in circuit, powered down, in diode multimeter mode, both directions

low resistance gate-source can mean blown LX1682, would result in same symptoms, testing will require desoldering to check

Here's a photo of what I mean. Explanation on the bottom of the picture.

your pinout is wrong, your conclusions are wrong, pin 1 is gate

again
>again
>>the only thing you should measure is drain-source junction
>while in circuit, powered down, in diode multimeter mode, both directions

>low resistance gate-source can mean blown LX1682, would result in same symptoms, testing will require desoldering to check

rasz_pl wrote:

the only thing you should measure is drain-source junction
while in circuit, powered down, in diode multimeter mode, both directions

I get infinite resistance on all FETs when I do that.