First post, by feipoa
For me, one of the great disappointments of the AWE64Gold is the lack of a wavetable header. Thus the Chill & Phil midi adapter was born. This allows you to add the DreamBlaster X1, X2, S1, and S2 to the external game port of your sound card. What has always bothered me about this is that the DreamBlaster would stick out the back of the computer case. The larger the wavetable card, the further it sticks out. Shown here,
If you are like me and always move cases in and out of the closet for testing, the DreamBlaster sticking out of the back was a general annoyance, so much so that I just left it unconnected and didn't bother to use it. With the low profile of the Chill & Phil and the S1/S2 midi cards, I thought it would be beneficial to rotate the adapter 90 degrees so that it doesn't stick out any more. So I picked up a normal orientation DB15.
Unfortunately, the pins were too short, so I had to add some extension headers to it. Unfortunately, the pin spacing of the DB15 isn't quite the same as the standard 2.54 mm of pin headers, so I had to cut my headers in two's and solder them as pairs. The results are attached.
More ideal would be to make an alternate version of the Chill & Phil with the normal orientation DB15 connector on the flip side of the PCB, and to re-trace the PCB for this flipped orientation.