First post, by PaXLiCh
Aztech Sound Galaxy Basic 16 - I38-MMSN810
trying to get this card to work in Windows.
got drivers here http://www.vogonsdrivers.com/getfile.php?file … menustate=41,36
PC 486DX-66 32mb
Address which can be configured with jumpers correctly set in resources for device.
This card works quite normally under DOS.
But when loaded into Windows 95, in the list of devices it is marked as "could not start, code 24", but does not show any resource conflicts.
Sometimes if change address or interruption / dma in the resources, then it turns out to be revived (the card stops noising, is determined by the system and a sound plays)
and if you just reboot, then the sound may not even be lost, and it will work fine.
If turn PC off and on, then the sound is no longer detected, you have to go to change the dma from for example 03 to 00 and the sound comes to life, then after "switching" it back from 00 to 03 so that the sound starts working again.
The AWE Blaster had a similar problem, but the opposite, in DOS the sound did not work until you run one utility, maybe also need to kick the card somehow?
Maybe something tricky needs to be done with the driver settings, maybe there is a way to find the problem with some utility?
Maybe I not understand the idea of resource values? Maybe card needed to be configured properly with HWSET to work under windows with same values of dma irq?