486 PIO-2 AMD 5x86 Jumper settings \ VOGONS

486 PIO-2 AMD 5x86 Jumper settings

Topic actions

Post a reply

First post, by appleiiguy

Posted on 2015-02-05, 14:23

appleiiguy Offline

Rank Newbie

Rank: Newbie
Posts: 60
Joined: 2014-11-29, 11:29

So I got a 486 PIO-2 and the manuals online dont have any settings for an AMD 5x86 P75.
Currently I have it set for 3.45V, 2x Multiplier, 33 Mhz, and set it to Enhanced AMD 486DX4 (which should set the cpu to WB cache), and I have 512KB of cache installed.

I believe It is the correct setting but since the manual doesnt have the 5x86 setting in it I was hoping someone on Vogons had done this setup before.

ftp://ftp.fic.com.tw/motherboard/manual/486/4 … 2/486-pio-2.zip <-- The Manual

Reply 1 of 3, by Living

Posted on 2019-11-17, 14:48

Living Offline

Rank Member

Rank: Member
Posts: 165
Joined: 2014-01-26, 20:01
Location: Buenos Aires, Argentina.

i got the same question

Reply 2 of 3, by jesolo

Posted on 2019-11-17, 16:31

jesolo Offline

Rank l33t

Rank: l33t
Posts: 2106
Joined: 2014-06-24, 19:04
Location: South Africa

What happens if you boot up the PC?
Does it POST and what does it display on the POST screen?

Reply 3 of 3, by mpe

Posted on 2019-11-17, 18:16

mpe Offline

Rank Oldbie

Rank: Oldbie
Posts: 1084
Joined: 2018-06-12, 21:19
Location: London, UK

The AMD 5x86 P75 is the same thing as Enhanced AMD 486DX4 and needs identical settings.

Or you can use settings for Intel DX4-WB (P24D) which has identical pinout.

https://stason.org/TULARC/pc/motherboards/F/F … -486-PIO-2.html

The only extra thing 133 MHz needs is the 4x multiplier which should be easy to find. If you have a multimeter it is the R17 pin (second pin in bottom right). This pin needs to be set to high to enable 4x multiplier.

Blog|NexGen 586|S4

Go to top of page Go to top of page

Back to General Old Hardware

Main menu

Common searches