First post, by Scottmm
I have a 286 board I need help(the jumper settings with). G2-102 Headland very similar to the Motherboard: LM-103S http://minuszerodegrees.net/at_clone_bios/at_clone_bios.htm
Board originally had 1025KB Onboard RAM via DIPs and 2 banks of 30 pin rows soldered over. I removed the solder from the board and installed sockets then took some 256KB and 1MB SIMMs and turned them into SIPPs. The board was only seeing one set of ram so after removing the DIPs and installing the 256KB SIPPs in bank 0 I got 512KB good but with the 2 1MB in bank 0 I got also only got 512KB, some random jumpering and switch flipping I found that DSW1 sw2 to on allowed my memory to be fully detected.
Does anyone have know where to find a copy of the manual or at least a Jumper diagram.
Board also has a odd issue where the Keyboard will not respond till after the bios pops up with a cmos error at boot (can't skip memory count and with 2MB its a long count)