First post, by NightShadowPT
- Rank
- Member
Hi,
I'm trying to make my boot as clean as possible and I'm using the Silent option (whenever available) when I install and configure my devices on Autoexec.bat and config.sys.
Nonetheless, not all of them seem to have the silent option and the verbose is displayed on screen.
On autoexec.bat I found that if I redirect the output to "null device" (using the ">nul" command after each line) I can avoid seeing the verbose, but on config sys I am not aware of anything similar I can do.
I am currently struggling with the CD-ROM SCSI device drivers from Adaptec:
ASPI7DOS.SYS
ASPICD.SYS
As I cannot seem to find the option to make them silent...
Any suggestions?
Thanks
Update: Corrected "console" to "null device" - thanks to analog_programmer for the correction.
NightShadowPT
----------------
Compaq Deskpro M 486/66 - 64MB Ram - Compaq QVision 1MB - Orpheus II Sound
Card - 4GB SCSI HDD + 4GB CF Card - SCSI CD-ROM Plextor PX-32TSi - Adaptec WideSCSI AHA-2740W - 3COM Etherlink III Card