VOGONS

Help getting jumper settings/manuals for unsual motherboard

Topic actions

First post, by remi020878

Posted on 
User metadata
Rank Newbie
Rank
Newbie

Hi all! Trying to get a link or an image of a manual or jumpers settings for the correct cpu on this unusual mobo. I have found a topic and a discussion on this board from few years ago, but the links to manuals are long dead. I am trying to set it correctly for an AMD DX4 100MHZ cpu. The board is MarkVision Flexboard Ver 2.1 H21d. Apparently some Biostar Mb-14xx with 2 VLB slots jumpers are the same but I cannot find those either. The available ones are for 3xVLB boards. I hope one of you still has them. Thank you so much. Attaching picture of the board 8n question.

Reply 2 of 6, by remi020878

Posted on 
User metadata
Rank Newbie
Rank
Newbie

It's (NV8T) so a regular one. Yes, you are absolutely right, it is still being sold on ebay. That's where I got that one. I m Kimhave read the tread you referred to as well as the other one from a fellow that tried to set it up for his dx4. I also read the link in the old thread about dx4 pin outs. In the previous discussion, one of the users had supplied links to another site with jumper settings and apparently these worked. I have been looking through internet intensly to no avail. Those settings were for a Biostar board, which apparently this one is a rebrand of. The board itself has printed a lot of settings, but the only CPU sett8ng printed on it is for Cyrix dx2 cpu. The rest isn't there unfortunately and is only included in a manual.

Reply 3 of 6, by progman.exe

Posted on 
User metadata
Rank Member
Rank
Member

> Filename Screenshot_20240604_135329_eBay.jpg

/facepalm

Reply 4 of 6, by Disruptor

Posted on 
User metadata
Rank Oldbie
Rank
Oldbie
remi020878 wrote on 2024-06-04, 22:44:

It's (NV8T) so a regular one. Yes, you are absolutely right, it is still being sold on ebay. That's where I got that one. I m Kimhave read the tread you referred to as well as the other one from a fellow that tried to set it up for his dx4. I also read the link in the old thread about dx4 pin outs. In the previous discussion, one of the users had supplied links to another site with jumper settings and apparently these worked. I have been looking through internet intensly to no avail. Those settings were for a Biostar board, which apparently this one is a rebrand of. The board itself has printed a lot of settings, but the only CPU sett8ng printed on it is for Cyrix dx2 cpu. The rest isn't there unfortunately and is only included in a manual.

(N)V8T has to be jumpered like a regular DX/DX2, but with 3.3 Volt

Reply 5 of 6, by remi020878

Posted on 
User metadata
Rank Newbie
Rank
Newbie

Thank you for that tip. I believe the board is set to that by default but, without actual manual, I won't really know. Disruptor, I believe you were the guy that provided those links in the old tread via win3x.org site if memory serves me right. I did look in there and it's mostly in French😃 but I wasn't able to find anything. I think those were links to an equivalent/similar Biostar board.

Reply 6 of 6, by remi020878

Posted on 
User metadata
Rank Newbie
Rank
Newbie

I just went through another tread posted here and indeed there is a picture that I needed! Thank you all for help!

Go to top of page Go to top of page
Back to General Old Hardware
Close window
Close window