Hello, I just got a K-568 LED display I plan on using on a ASUS 486 ISA V2 motherboard.
Here's my question. Am I missing header pins for (P-, P+, T-, T+) on the K-568 LED board?
I have referenced minuszerodegrees.net by googling "K-568 LED" and I just don't know.
See Pic.
Thanks in advance.
Yes, they are obviously missing and, as it seems, never installed. But you do not really need them - both the turbo led and the power led on the front of the case can be fed directly from the motherboard and then the connectivity looks like this:
Beautiful pic. Thank you. I'm getting a turbo switch with the requisite pin wiring in the mail over the next couple weeks and will give it a shot. I'll be in touch if I have other questions.
I did have a follow-up question. Where can I source or make the necessary wires. I've been googling 5V 2 pin or 2 pin to molex without much luck
Looks like I need:
1. 5V 2pin to PSU? (black and green wire on pic) My ASUS 486 ISAv2.4 motherboard doesn't have a power pin out for the MHz that I can see.
2. Turbo LED power (3 pin) to motherboard (2 pin)
thoughts?
Here is a pic of the motherboard I have with the connectors in the lower right corner.
