dr.zeissler wrote on Today, 15:12:
Interesting, thx for sharing that info. I don't have a clue what's wrong though.
I tested exactly 6 graphics cards on my Asus SP97-XV motherboard with an AMD K6-2 400 processor and 128MB of SDRAM, running MS-DOS 6.22.
The tests were performed using 3dbench2 and Quake 1 (at resolutions of 320x200 and 800x600).
UniVBE 6.7 is enabled in the autoexec.bat file. Here are the test results.
1. Tseng ET4000W32p:
=> Q1 800x600 = yes,
=> 3dbench 259.0 fps;
=> Q1 320x200 = 56.6 fps
2. ARK2000 Hercules Stingray 64:
=> Q1 800x600 = yes,
=> 3dbench 307.9 fps;
=> Q1 320x200 = 57.0 fps
3. V3-3k PCI:
=> Q1 800x600 = yes,
=> 3dbench 307.9 fps;
=> Q1 320x200 = 57.0 fps
4. S3 Trio 64:
=> Q1 800x600 = yes,
=>3dbench 306 fps;
=> Q1 320x200 = 56.0 fps
5. Matrox G450: (what a miracle, regardless all warnings in internet, it works with a non_intel chipset mainboard Asus SP97-XV @ SiS 5582
=> Q1 800x600 = yes,
=> 3dbench 271 fps;
=>Q1 320x200 = 57.1 fps
6. Matrox 220 with 4MB RAM:
=>800x600 = no (blank screen at all SVGA resolutions regardless what Hz is set by unirefresh or unicentre),
=>3dbench 305 fps;
=>Q1 320x200 = 57.1 fps
6: I even tried connecting it to a 2009 Sony HD-ready TV via VGA; the result in SVGA was the same: a blank screen.
EDIT:
I seem to be overworked as I had completely forgotten, that at the beginning of november I had a K6-233 ANR on the Asus SP97-XV with no K6-init loaded and then the Matrox Mystique 220 worked on the Asus SP97-XV:
Quake1 software mode 640x480, 800x600 (not) possible although same graphics card, but different boards?
Conclusion: it must be K6-2 400 and K6init which enables write combining but causes a problem with the Matrox Mystique 220. Furthermore you should avoid Asus EyeCare 23" monitors as only my Asus VS247HR worked with the Mystique in SVGA resolutions.
DOS:P233MMX,64MB,ECS,SpeaMirageV7,3dfxV1,AWE64,ESS1868,PicoGUS,32GB
W98SE:K63/400,256MB,P5A,Verite2200AGP,3dfxV2,M3D,AWE64,ESS1938,PicoGUS,64GB
XP:P3-1G,512MB,CUSL2C,FX5600AGP,Audigy1,80GB