First post, by kapcon
- Rank
- Newbie
one of my DOS programs creastes a configuration file while running, but if i try to run this program, i get this error: "file cannot be created DOS code 2" how do i fix this?
thanks
BeWell
dovid
one of my DOS programs creastes a configuration file while running, but if i try to run this program, i get this error: "file cannot be created DOS code 2" how do i fix this?
thanks
BeWell
dovid
do you know what file is not being created ?
if so create an empty txt file with the same name and extension
if its config.cfg make sure it is config.cfg and not config.cfg.txt
then run your program
Guardian of the Sacred Five Terabyte's of Gaming Goodness
dear guardian,thanks i'll try that... btw, i like your avatar. i'm having trouble uploading one, any advice?
thanks
BeWell
dovid
i fixed my problem, but not via the text file. i unknowingly had another seession of that DOS program open but minimized, so the Config file could NOT be written to, since it was open. i'm guessing that Dos Code 2 means the file was open.
thanks
BeWell
dovid
about your avatar
"It must be less than 120 pixels wide, 120 pixels tall, and 64 kB in size."
Guardian of the Sacred Five Terabyte's of Gaming Goodness