First post, by jim78b
- Rank
- Member
hello everyones! i have a trouble. i owner of a schneider euro pc 8088 with a cgaout db9 pin, i have i monitor commodore 1084 s ,how i can the cable for connect my old pc to it?
i post specifications of monitor
1084S
Picture Tube: 14 inch (13 inch viewable), slotted triplet pitch 0.42 mm
Deflection: 90°
Monitor input sockets for RGB signals:
9-pin D: RGB Analog 0.7 P-P, 75 Ohm
DIN connector: RGBI Digital TTL Levels
Resolution: 640 x 200 lines, 640 x 400 lines interlaced
Characters: RGB, RGBI, 2000 characters, Composite, Seperated LCA, 1000 characters
Raster Frequency: 50 or 60Hz
Line Frequency: 15625 - 15750Hz
Sound Output: 1WRMS
Audio Signal: 1.0V P-P, 47K Ohm
Mains Voltage: 120 VAC, 60Hz
Power Consumption: 75W
Dimensions (H x W x D): 330 x 357 x 378 mm
Weight: 11 kg
Looking at the back of the monitor
Digital Analog
Pin Number TTL Mode RGB Analog Mode
1 Ground Ground
2 Ground Ground
3 Red Red
4 Green Green
5 Blue Blue
6 Intensity N/C
7 N/C Composite Sync
8 Horiz.Sync N/C
9 Vert. Sync N/C
my question is, i shall connect which pins from my pc db9 to my pin 8,9 my monitor? cga is a ttl signal?
CGA PINOUT
1 GND Ground
2 GND Ground
3 R Red
4 G Green
5 B Blue
6 I Intensity
7 RES Reserved
8 HSYNC Horizontal Sync
9 VSYNC Vertical Sync