I have Quake v1.08. Whenever I quit the game, all controls, mouse sensitivity and video options go back to default. I'm tired of setting them all over again. Can anyone help to keep them saved? I use Win7 64-bit and DOSBox 0.74.
Be sure the game files are not read-only.
Also press D after you changed your options to save them as default.
id1/config.cfg is either set read only, or there's an autoexec.cfg overriding it
it's also possible that you don't even have write access to your quake folder for some reason
Do I have to edit the config.cfg or something?
attrib -r <yourquakebase>\id1\config.cfg
wrote:attrib -r <yourquakebase>\id1\config.cfg
Is that a command parameter or are you pointing out the location of the .cfg? I opened the file and see this:
bind "TAB" "+showscores" bind "ENTER" "+jump" bind "ESCAPE" "togglemenu" bind "SPACE" "+jump" bind "+" "sizeup" bind "," "+movel […]
bind "TAB" "+showscores"
bind "ENTER" "+jump"
bind "ESCAPE" "togglemenu"
bind "SPACE" "+jump"
bind "+" "sizeup"
bind "," "+moveleft"
bind "-" "sizedown"
bind "." "+moveright"
bind "/" "impulse 10"
bind "0" "impulse 0"
etc.
attrib -r removes the read-only flag on a file.
My collection database and technical wiki:
https://www.target-earth.net
That didn't help. I wrote:
''Z:\>attrib -r c:/dosbox70/quake/data/id1/config.cfg''
Did I wrote something wrong? Note that I renamed my Dosbox -directory to ''dosbox70'' and keep my games there.
wrote:I wrote:
''Z:\>attrib -r c:/dosbox70/quake/data/id1/config.cfg''
I think you would do it after mounting the path as C:\.
You could also navigate to it normally and right-click, then select properties to see if it has any attributes set.
you have to do this on your host operating system.
DOSBox does not support setting file attributes
Water flows down the stream
How to ask questions the smart way!
wrote:You could also navigate to it normally and right-click, then select properties to see if it has any attributes set.
That helped, thanks.
This is a Quake problem, not a dosbox problem. Quake is well known not to remember settings and stuff. in your Quake/ID1 directory make a text file and call it autoexec.cfg and put all your settings in there. There's tons of info about Quake on http://quakeone.com on setting up quake.
