First post, by tincup
- Rank
- Oldbie
I'd like a window in the side of my Lian A05FNS case [clear brushed]. My thought was to hole-cut the corners with a fine tooth bit then hand saw the straights using a 30+ tooth hacksaw and straightedge. I'd mark the lines on wide strips of masking tape first, and file the cut edges smooth when done.
For the window itself I have a sheet of 1/8" clear acryic ready, and plan to mount it on the inside face of the panel using 1/8" thick neoprene washers as standoffs to allow for perimeter ventilation.
I'll experiment on some scrap first of course, but welcome any advice or recommendations here...