Problem with Seagate ST02 SCSI \ VOGONS

Problem with Seagate ST02 SCSI

Topic actions

First post, by RiP

Posted on 2019-07-05, 20:48

RiP Offline

Rank Member

Rank: Member
Posts: 240
Joined: 2017-11-24, 09:05

I try to get my ST02 to work but it reports: "SCSI Host Adaptor Failure"
The floppy port works fine though 😕

Reply 1 of 2, by Warlord

Posted on 2019-07-05, 21:12

Warlord Offline

Rank l33t

Rank: l33t
Posts: 2552
Joined: 2018-02-02, 05:14

make sure the scsi cable is terminated. Check the drive ID jumpers and that its not sharing same ID with the controller, floppy or other device on the cable.

Try connecting just the drive to the controller with no floppy attached as well.

Reply 2 of 2, by RiP

Posted on 2019-07-10, 17:00

RiP Offline

Rank Member

Rank: Member
Posts: 240
Joined: 2017-11-24, 09:05

Warlord wrote:
make sure the scsi cable is terminated. Check the drive ID jumpers and that its not sharing same ID with the controller, floppy or other device on the cable.

Try connecting just the drive to the controller with no floppy attached as well.

Thank you, just terminated the HDD and ST02 detected it 😎

Go to top of page Go to top of page

Back to General Old Hardware