Reply 20 of 32, by feipoa
- Rank
- l33t++
slivercr wrote on 2020-06-06, 04:01:feipoa wrote on 2020-06-05, 11:56:...
Ideally I'd like to figure out how to remove the CPU's plastic casing and adjust the CPU multiplier in a manner similar to the gold finger devices (GFD), http://www.cpu-world.com/forum/viewtopic.php?t=28887 I'd like to run the board at 850, 900, 950, and 1000 MHz to determine the fastest stable operating speed. Doesn't seem like I'll run across a GFD anytime soon so I'd have to do some messy solder work, then remove the mess.I've never used either SlotA nor a GFD, but you can look to Robert B (Bobby B?!) for guidance on how to open the cartridge.
I saw that he had a hard time removing the slot A enclosures. Would have been nice to see the photos embedded with the text so it is easier to follow. When I messaged CPU-Shack about removal of the enclosures, he said he had no issue whatsoever. Thus I'm not sure why the discrepancy here.
Plan your life wisely, you'll be dead before you know it.