First post, by quicknick
- Rank
- Oldbie
A heatsink was needed for another project, so I pulled one from an old GF2MX400 card I had in the "non-important" card box. Noticed some shadowing under the markings, and this picked up my interest so I started rubbing the surface with a strong solvent. The re-marking was very well done, in the end I had to scrape with a very sharp razor to get to the relevant bit of the original markings. Turns out the MX400 is really a MX200 in disguise.
I can understand faking high-end chips, but this is a first for me. Anyone experienced such low-end faking?