Hello everyone,
I am trying to run Hovertank 3D v1.17 under 86box emulator, but I am getting this error message after the splash screen:
This is 86box VM:
It's running MS-DOS 6.22
config.sys:
autoexec.bat:
Please help! Thanks 😀
I don't know why you have "net start" in your autoexec.bat if you are running DOS 6.22? Taking that out might help for starters.
You can also try using LH in front of the MSCDEX line, and DEVICEHIGH for the CD-ROM driver in config.sys. If all else fails, you can copy all the files off the emulated CD-ROM drive and then boot your computer completely without CD-ROM drivers.
Jorpho wrote on 2021-03-03, 20:29:I don't know why you have "net start" in your autoexec.bat if you are running DOS 6.22? Taking that out might help for starters.
You can also try using LH in front of the MSCDEX line, and DEVICEHIGH for the CD-ROM driver in config.sys. If all else fails, you can copy all the files off the emulated CD-ROM drive and then boot your computer completely without CD-ROM drivers.
Did all of that, and it worked! Thanks 😀
I have network enabled because I was playing around with Windows for Workgroup 3.11.
It is not possible to run Hover with these drivers enabled at all?
I forgot to mention that, loading the drivers on high memory did not help.
A fella in 86box's Discord said:
perhaps replace RAM in the emm386 line with NOEMS
And that did it! Thank you 😀
