First post, by PaulECW
Hello,
I apologize if I'm in the wrong area to ask this but I'm at whit's end...
I have a client that uses DOSBox... and to make a long, filled-with-gaps-story short, he uses it to calculate "beam sizes" (his words). He was recently setup on a new PC and the DOS config files and everything else were copied over.
According to him, at the end of punching in the different inputs to calculate the beam size, a "calculation sheet" should popup detailing the inputs and the beam size calculation for him to print/provide to his clients. This is no longer happening on the new PC and the old PC is gone with.
I realize I'm probably not leaving enough bread crumbs to get an appropriate answer but I'll take anything that could help point me in the right direction.
EDIT: Resolved. Issue was PrintFil wasn't launched when user was trying to print.