Interesting, I'll look into that and at least try it on one spare card I have.
In other news, my RGBtoHDMI board arrived today..
Amiga RGBtoHDMI 01.jpg
..so now this is ready to go into my A500.
Amiga RGBtoHDMI 02.jpg
But I'm not sure whether it will actually replace this or provide any additional benefits, particularly because getting the HDMI cable out of the case requires modding it in some capacity (I can't use the sidacart door, I have an ACA500Plus there).
Amiga HDMI-520.jpg
But maybe I'll end up using both to have deal HDMI out, one for viewing and one for capturing.
Oh, and these also came in the mail, so time to start soldering up some MT32-Pi-MIDI-Hat boards!
MT32-Pi-MIDI-Hat PCB.jpg
I also acquired this Fujitsi P3-1.2GHz laptop a while ago but it had some problems (dead CMOS battery, XP install with 768MB RAM) so I opened it up, gave it a good clean, replaced the CMOS battery, reduced RAM to 512MB and installed Win98SE on it.
Fujitsu Lifebook S6110 Win98SE.jpg
Will be installing drivers on the weekend. Apparently the audio codec (Sigmatel C-Major) has Legacy audio support in Win98SE and we'll see how well that works.. It also has i830MG Almador graphics, which I have no clue about, and we'll see how well that actually works as well. If it can run Quake 1/2 I'll be happy enough, I'm not expecting more than a Voodoo 2 out of it to be honest.
Retronautics: A digital gallery of my retro computers, hardware and projects.